![]() Be sure to give the main object a unique ID. Add the SVG/XML data into the DEFs section of the HTML. You can add additional SVG images (from Illustrator, Inkscape, etc). The unicode value is required in order to display a preview in the drop down select box. ![]() You'll need the unicode value (in hexadecimal) of the icon and the icon name (fa-xxxxx). You can add additional Font Awesome icons by adding them to the FontAwesomeIcons array. If you want to customize the code to add additional images.Ĭurrently all the code is embedded in the HTML file. You can use a hot glue gun to apply a bead of glue around the outer edge of the light to affix it to the pumpkins foam. Place the tea light in the hole, far enough that the pumpkin can sit flat (but not so far that it falls into the pumpkin). Now is a good time to shake out any foam pieces that fell into the pumping while carving. A snug fit makes it easier to adhere the light in place. Test the fit, and enlarge the whole if needed. Cut a little smaller than you think, so the tea light will be snug. Now use a sharp knife to cut out the circle diameter you traced. Use a pencil to trace around the diameter of the LED tea light. You can not put the put the lid back in place.Ĭenter the tea light on the bottom of the pumpkin. If using a candle tea light you can use a long match or long lighter to light it when already inside the pumpkin. Place the tea light in place through the opening on the top (you made early). They sell battery operated LED tea lights, and tea lights that can be plugged into a wall socket. Foam/craft pumpkins must only be lit by low wattage bulbs. Real pumpkins can be lit by candle/tea lights or by LED tea light. If using a foam pumpkin, avoid pumpkin's seams as the front face.I find this works better on real pumpkins than the craft/foam pumpkins. When the paper is removed you will have the outline as a series of dots (kind of like "connect the dots". You'll want the holes close enough so you can follow along later to cut, sand, or paint the areas as desired. You can use a needle or pin to poke holes through the paper of the template and into the pumpkin.This doesn't work well of craft/foam pumpkins, but could be okay on a real pumpkin. If you press hard enough you can skip the carbon paper, and just use the serrated tracing wheel.This will leave a pencil like sketch, of the edges you traced, on the surface of the pumpkin. Use a pencil or serrated tracing wheel to follow around the edges of the template (make sure the carbon paper is under the area you are working on). I find it easier to use smaller pieces (rather than a full sheet) and move it around as needed. Place carbon paper (face down) between the pumpkin and the template.Once taped, you can transfer the image by one of these three methods: You could also cut the mouth into a separate piece before taping to the pumpkin. I sometimes find it helpful to cut the template strategically so that it wraps around the pumpkin better. All the methods I've used require taping the template to the pumpkin to keep it in place as you are working. There are a few techniques for transferring the template to the pumpkin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |